JZC-S计重电子台秤校正资料
1． 将电子秤主板的校正端子S1，S2拔插至“CAL”端；
2． 开机自检结束显示满量程值，单位为g；
3．电子秤 按“去皮”《T》键选择所需量程并按“置零”键确认，显示分度值为g；
4．电子秤 按“T”键选择所需分度值，并按“0”键确认，显示零点内码；
5．电子秤 按“T”键进行零点校正，显示“b+内码”，放1/3满量程砝码；
6． 稳定后按“0”键确认，显示“C+内码”，在加1/3满量程砝码；
7． 等电子秤稳定后按“0”键确认，显示“d+内码”，在加1/3满量程砝码（秤盘上的砝码值为满秤量值）；
8． 等电子秤稳定后按“0”键确认，确认完成显示满量程值，校正完成取下砝码并关机将S1，S2拨插到称重端。
JZC-S计重电子台秤 外部校正
1．电子秤 按住“0”键不放开机自检到显示“CAL”；
2． 在按“0”键显示《0》；
3． 放上砝码，按单位转换键输入数字按“T”键移位，输入砝码值，单位为g；
4． 稳定后按“0”键确认，显示砝码重量值，校正完成。
A． Interior calibrate
1. Open the scale,move the switch S1,S2 to the”CAL”;
2. It will display”ALXXg”(XX—interval value) after power-on self-test.change it by pressing the key”T”,and confirm it by pressing the key”0” ;
3. It will display interval quantity,change it by pressing the key”T”,and confirm it by pressing the key”0”;
4. Then it well show the zero ISN,callbrate the zero by pressing”0”,it will be show at the place before ISN soon,place 1/3MAX.CAP on the pan at this time,pressing the key”0”after the scale is stable,current ISN is show;
5. Place 2/3MAX.CAP,calibrate it by pressing”0”,it will display the weight have been piaced;
6. Remove the weight and turn off the scale,reser the switch S1,S2 to the “NORMAL”end;
7. Turn on the scale,recalibrate the scale if it is not work properly;
B.Exterior calibrate
1.Turn on the scale by press”0”,it will display”CAL”after power-on self-test;
2.Place2/3MAX.CAP on the pan,confirm it by pressing “0” when the scale is stable,it will display the weight have been placed,The exterior calibrate is finished.
以上校正资料由上海毕胜实业技术部提供